Damp & timber inspections in London

Damp has a cause. We find it.

Independent damp investigations by RICS-regulated surveyors. We measure the moisture, trace it to its source and tell you plainly what will stop it, so you pay to fix the cause rather than cover the stain.

  • Regulated by RICS
  • Chartered member of CABE
  • Independent advice
Moisture map Move across the wall to take a reading
—%WME
Reading…
— above floor
The stain shows where damp has been. Readings show where it is now. Simulated readings for illustration.

Three kinds of damp, three different fixes

Most damp comes from one of three places. They can look alike on a wall, which is why so much damp is treated with the wrong cure.

Condensation

Water from the air inside, settling on the coldest surfaces.

Looks like
Streaming windows, black mould in corners and behind furniture, worse in winter.
Usually fixed by
Better ventilation, steady heating, insulation at cold spots.

Penetrating damp

Rain finding a way in through the walls or roof.

Looks like
Patches that grow after rain, often high up or around windows and chimneys.
Usually fixed by
Repairing gutters, pointing, render, flashing or the roof.

Rising damp

Ground moisture drawn up the base of a wall.

Looks like
A tide mark low on the wall, salts and blown plaster near the skirting.
Usually fixed by
Lowering ground levels or removing what bridges the damp-proof course, and only then a new one if needed.

Where are you seeing it?

Pick the place that looks most like your problem to see what usually causes it and what a surveyor would check.

Low on the wall

A tide mark up to about a metre high, blown plaster, white salts or peeling skirting paint.

Common causes

  • A bridged or failed damp-proof course
  • Paving, soil or render too high outside
  • Leaking pipes or drains
  • Condensation at skirting level
  • Genuine rising damp, which is rarer than often claimed

What we’d check

  • A profile of readings up the wall
  • Outside ground levels against the damp-proof course
  • Render, paths or extensions bridging it
  • Plumbing and drainage nearby
Get this checked

What happens on an inspection

We look at the building as a whole, inside and out, because the cause of damp is often a few metres from where it shows.

  1. Tell us what you’re seeing

    Four quick questions online, or a phone call. We’ll confirm the details, the fee and a time that suits you.

  2. We take readings inside

    A pattern of moisture readings across affected walls and timbers, plus room humidity and surface temperatures to test whether condensation is to blame.

  3. We trace it outside

    Gutters, downpipes, pointing, render, ground levels, airbricks and plumbing: anything that could be letting water into the building.

  4. You get a clear report

    The cause, the evidence behind it, and remedies in a sensible order, starting with the simplest. Written in plain English, not sales language.

The cheapest fix is the right diagnosis.

Injected damp-proof courses, tanking and replastering all have their place. But none of them will cure a blocked gutter, a leaking pipe or paving piled against a wall. Our report puts the remedies in order, so your money goes on the cause first.

How we read moisture in timber
Under 17%
Dry
17 to 20%
At risk of decay
Over 20%
Wet enough for rot

On brick and plaster, meters give relative readings, so we look at the pattern across a wall rather than any single number.

Who books a damp inspection

Buyers

A survey, lender or agent has flagged damp. Find out the cause and the likely remedy before you exchange.

Homeowners

Mould that comes back every winter, a patch that never dries, or a room that smells musty.

Landlords and agents

Get to the cause quickly when a tenant reports damp or mould, with a clear record of what was found.

Second opinions

Quoted for a new damp-proof course or tanking? Check it’s the right cure before you pay for it.

Questions people ask

Read our damp checklist for London homes for what to look for on a viewing.

Is a damp inspection the same as a Level 2 or Level 3 survey?

No. A home survey looks at the whole property and will point out signs of damp, usually with moisture readings where walls are accessible. A damp inspection concentrates on the damp itself: where the moisture is coming from, how far it has spread, and what will stop it. If you are buying, you may want both.

A survey or my lender has flagged damp. What should I do?

Book an inspection before you exchange. Knowing the cause and the likely remedy lets you budget properly, ask the seller to put it right, or renegotiate with evidence rather than guesswork.

Is rising damp real?

Yes, but it is diagnosed far more often than it actually occurs. Many walls blamed on rising damp turn out to be wet from condensation, a leaking pipe, a bridged damp-proof course or ground levels that are too high outside. The fixes are completely different, so the diagnosis matters.

Will you drill holes or damage my walls?

Most of our readings are taken with non-invasive meters on the surface. If a more intrusive test would genuinely help, we will explain why and ask before doing anything.

Do I need to be there?

Not necessarily. An estate agent, landlord, tenant or keyholder can give us access instead. Tell us who to contact when you make your enquiry. We will need to get inside and around the outside of the building.

Do you cover my area?

We inspect properties across London, including Barnet, Brent, Camden, Ealing, Enfield, Harrow, Islington, Richmond and the surrounding areas. If you are not sure, send an enquiry and we will let you know.

Tell us what you’re seeing.

Four quick questions, then we’ll contact you within one working day to arrange the inspection. Sending an enquiry doesn’t commit you to anything.

Inspections across London, including Barnet, Brent, Camden, Cricklewood, Ealing, Enfield, Finchley, Haringey, Harrow, Hayes, Hendon, Islington, Kilburn, Richmond, Uxbridge, Wembley.